FAQs


SPS squeegee is classified into three major categories: 1. Traditional M-type squeegee (without support plate). 2, FGB fiberglass scraping. 3, AS unilateral carbon fiber scraping gum.

There are currently two models, one is the M-type rubber used in the M-type and FGB fiberglass panels, and the other is the PLUS rubber used in the AS-carbon fiber (conductive, more solvent-resistant, and more wear-resistant).

M models have 9*50, 9*30, 7*40, 5*25, 5*20 tip thickness according to thickness, and can be customized according to customer requirements.

The traditional screen printing industry FGB fiberglass scraping specifications of 9 * 50, the length of cutting according to customer requirements. Can be customized according to customer requirements.

The traditional screen printing industry AS carbon fiber scraping specifications 7*50, length according to customer requirements. Can be customized according to customer requirements.

3D: STP, XT; CAD: 2000 version, custom time: within 5 working days

The three types of scraper can be ground. M model and FGB model single maximum grinding amount 0.5mm (200 mesh grinding wheel). AS carbon fiber scraping single maximum grinding amount 0.1mm (200 mesh grinding wheel, carbon fiber board can also be ground). The squeegee that has just been used up contains a lot of solvent inside. The hardness of the knife edge is too low to be ground immediately. It takes only 24 hours before grinding.

Both the FGB fiberglass scraper and the AS carbon fiber scraper are 1.2mm thick. They can be installed with an 8mm thick pad, which we can provide.

The squeegee is printed for a long time, and the solvent easily erodes the squeegee blade. The hardness and wear resistance of the squeegee are reduced. Therefore, after the squeegee has been printed for a long time, it needs to be cleaned, and after being left for 12-24 hours, it is used or ground again. If stored in a low-temperature environment, soak it in 30°C warm water for 10 minutes before use. Dry it with a cloth and use it. When the squeegee is left for a long time, it is forbidden to touch the other side of the squeegee to prevent the squeegee from deforming.